LEARN

Are we paying enough attention to the procedure for F2170?

The Importance of Doing the Concrete RH Test Correctly

The F2170 procedure for RH testing of concrete floor slabs states that we should - Insert the hole liner to the bottom of the hole. Cap or seal the open end of the hole liner and any open gaps at the top of the liner per manufacturer’s instructions. Allow 24 hours to achieve moisture equilibrium within the hole before making relative humidity measurements.

How to perform a non-destructive flat roof moisture survey to ASTM D7954

How to perform a non-destructive flat roof moisture survey to ASTM D7954

Obtaining as much information about the roof as possible in advance is invaluable. A set of roof drawings or plans make moisture mapping much easier and a knowledge of the construction will make the job of calibration much faster.

Working with the Dec Scanner

Working with the Dec Scanner

The Dec Scanner is by far the simplest device to use for moisture testing and leak detection of a flat roof, however even a small amount of training can help new users to avoid simple pitfalls.

Tramex Moisture Meter for Concrete

Concrete Moisture Testing with Tramex Concrete Moisture Meters and Probes

The Tramex moisture and humidity testing system for floor covering related industries has been developed to help users avoid moisture related problems in flooring and to identify the cause of problems if they do occur.

Moisture testing - Save time, money and boost your reputation

Moisture testing - Save time, money and boost your reputation

How simple, instant and non-destructive tests will save you time and money on your RH testing and strengthen your reputation.

Concrete Moisture Testing – Methods and Meaning

How to test concrete for moisture after water damage

When drying concrete after water intrusions it is important to monitor and measure the moisture content of the concrete in two phases: First during the drying phase; and again after the drying is complete.